MUSTA 3.0
3 PHASE POWER
*Before connecting any power source, please be aware of the mains power breaker on the vehicle*
Should at any time you or other people are at risk from an electrical hazard, turn the black breaker dial in a counter-clockwise direction to the off position. This will isolate connections from any power source and the rest of the vehicle.
It is advised that you park the vehicle as close as practical to the 3-Phase outlet location, remembering to maintain clearance both to the Northern sky where the satellite is positioned, and of overhead obstructions such as powerlines or awnings.
3-Phase outlets can commonly be found on or in most town halls, recreational facilities, school halls, camping grounds, and sporting grounds. It’s important to note if the 3-Phase power outlet you’re connecting to will be a 20Amp or a 32Amp connection. A 20Amp to 32Amp Cable Adaptor and 32Amp Cable is included in the vehicle if required.
The 3 phase cable is located in the bench-seat storage compartment along with protective cable tray.
- Begin your connection to the vehicle first.
- Lift the External Access Hatch to reveal the 3-Phase inlet connection point.
- Take the 3-Phase cable and line the pins of the cable up with the inlet connection point.
- Firmly connect the cable and once pressed into position screw the orange collar in a clockwise direction until firm.
- Next move to the connection at the 3-Phase outlet.
- Ensure that the 3-Phase outlet is switched off when connecting the cable.
- Following the same method as above, line the pins of the cable up with the outlet.
- Firmly connect the cable and once pressed into position screw the orange collar in a clockwise direction until firm.
- When ready switch the 3-Phase outlet into the ON position.