PCC

MUSTA 3.0 VEHICLE STABILISERS

Deploying Stabilisers

To deploy the stabilisers locate the Drill and 19mm Socket attachment. Additionally locate the yellow stabiliser pads in the TV cabinet.

Move to the driver’s side of the vehicle. 

With one hand push the stabiliser leg slightly up and with the other hand pull firmly on the handle.

Whilst continuing to pull the handles outwards, lower the stabiliser leg to a vertical position.

Place one of the stabiliser pads smooth side down on the ground approximately where the stabiliser will make contact.

Using the Drill and 19mm socket on the stabiliser leg engage the drill in a clockwise direction to lower the leg. Please be sure to keep hands and feet clear of the stabiliser leg.

The stabiliser should be lowered until stability is given, however not to the point of raising the vehicle height.

Repeat this process for the passenger side stabiliser.

Stowing Stabilisers

Before moving the vehicle it is crucial that the stabilisers are lifted for transport.

To stow the stabilisers locate the Drill and 19mm Socket attachment. 

Ensure that the Satellite dish is stowed.

Using the Drill and 19mm socket on the stabiliser leg engage the drill in an anti-clockwise direction to raise the leg. Please be sure to keep hands and feet clear of the stabiliser leg.

Pull the stabiliser handle firmly outwards with one hand and swing the leg towards the back of the vehicle until horizontal. Release the handle and ensure the leg remains in place.

Collect the stabiliser pad and repeat for the second side of the vehicle.

Be sure to return the stabiliser pads and the drill to charge within the TV cabinet.

Note that there is a manual stow handle available under the passenger’s seat which can be used to perform all tasks if the Drill and 19mm socket are unavailable or out of battery.