I have been able to get my hands on the video that shows you how to reset the lithium Ion batteries in the rear of the MUSTA 3.0 Vans. I have uploaded the video to our YouTube and now the video link is not behind an nbn login page.


It has also been uploaded to our Google Drive.


Direct YouTube link: https://youtu.be/zFTFJUV29wM


VQUIP Provided Steps:



Accessories and power needed:

  • 10A standard extension cord (there is one in the vehicle)

  • Power connection to one of the following:

    1. 10A standard wall outlet,

    2. Engine generator running, OR

    3. 3 phase outlet.

Steps for set up 2: Engine generator:

  1. Have the engine generator running

  2. In the back of the vehicle, twist the bottom bolts and raise the lift to expose the battery connections

  3. Connect one side of the 10A standard extension cord to the 240V outlet in the back of the truck, under the lights and switchboard. Connect the other end outside the vehicle in the 10A inlet (lift the flap, key is on the car keys)

  4. You will notice in the back of the vehicle that there is a reading on the 10A panel to the right of the switchboard

  5. Follow the video

  6. Once left charging for 30mins, disconnect the 10A standard extension cord from the 240V outlet and the side of the van

  7. Close the lid and twist back on the bolts

  8. Turn off the engine generator

  9. When storing, keep the vehicle plugged into 3 phase inlet or, 10A if 3 phase is unavailable (on the side of the vehicle)

 

 

Steps for set up 1: 10A standard wall outlet:

  1. In the back of the vehicle, twist the bottom bolts and raise the lift to expose the battery connections

  2. Connect one side of the 10A standard extension cord to the 240V outlet in the back of the vehicle, under the lights and switchboard. Connect the other end to the 10A standard wall outlet

  3. You will notice in the back of the vehicle that there is a reading on the 10A panel to the right of the switchboard

  4. Follow the video

  5. Once left charging for 30mins, disconnect the 10A standard extension cord from the 240V outlet

  6. Close the lid and twist back on the bolts

  7. Turn off the engine generator

  8. When storing, keep the vehicle plugged into 3 phase inlet or, 10A if 3 phase is unavailable (on the side of the vehicle)

 

Steps for set up 3: Connected to 3 Phase

  1. The vehicle is connected to 3 Phase

  2. In the back of the vehicle, twist the bottom bolts and raise the lift to expose the battery connections

  3. You will notice in the back of the vehicle that there is a reading on the 10A panel to the right of the switchboard

  4. Follow the video

  5. Close the lid and twist back on the bolts

  6. When storing, keep the vehicle plugged into 3 phase inlet or, 10A if 3 phase is unavailable (on the side of the vehicle)